- iModeler

DIY Pulley Wheels.

Started by Peter Hausamann · 4 ≡ · ↻ 5 years ago

Viewing 1 - 4 of 4 posts

Peter Hausamann said 5 years, 9 months ago:

Needed pulley wheels that were large yet very narrow. searched on the Internet, but non were available for my needs. Finally came up with the idea of making my own. Decided to sweat-solder a small washer between two larger ones. My first attempt did not look too good, but I learnt what was needed to get it right. Made eleven more pulley wheels.
Craig Abrahamson said 5 years, 9 months ago:

Looks like those are "just the ticket"...nice work.
neil foster said 5 years, 9 months ago:

What are they for ?
N.
Peter Hausamann said 5 years, 9 months ago:

Thank you @craigindaytona and @neil-foster for visiting the post.
To answer Neil's question, they are for a diorama I am currently building, the Wardell Bridge. The model will be a working lift span bridge. The wheels are for the cable-pulley system.

The link address to that build log is:
http://imodeler.com/groups/dioramas/forum/topic/wardell-bridge-1-72-scratch-build-wip/

Viewing 1 - 4 of 4 posts