Looking good, Brian! @brithebuilder
Shake the table and all those parts fall together...👌

The wing seams did not come out perfect, minor gap/offset that's not very noticeable. Once the decals and weathering are complete, I doubt anyone will be able to see any of the minor issues.

@gwskat - Thanks Gary, the masking on the glass was a challenge. Some Tamiya tape and a sharp blade... I felt like I was going to slip and gouge the glass the whole time.

Looks perfect from here, my friend @brithebuilder!

It looks like the pilot could crank the engine and takeoff, Brian (@brithebuilder). Nice job painting the pilot and getting him belted in. Did you print the figure?

Excellent work on the pilot and seatbelts, Brian @brithebuilder

Looking reeaealy nice, my friend @brithebuilder!

I believe the 1A is also finished. Weathered but not beaten... I think the glossy fuel stains coming out of the main fuel area look quite nice. I probably beat up the wing surface where the pilot is standing a bit too much, but it still looks pretty cool.

Alrighty, just a pair of simple dioramas to display the 2 together and they will be truly complete. The 1D will have a carrier deck (from Coastal Kits) and the 1A will have a sandy base with a couple palm trees that I 3D printed.

Thanks for following along!

5 attached images. Click to enlarge.