All of the nuances of the colors and different textures look great, Mike Norris (@sandbagger). Now comes the assembly of the sub-assemblies and wings. This is where I would crash and burn, but I know yours will look great.

The applied decals do look really nice, Mike @sandbagger

Weathering looks excellent, my friend @sandbagger!

Hi all,
A couple of modifications.

The aileron control cables exited the nacelle from their pulley fairings and were retained at the leading edge of each lower wing by either two or three cable fairleads, before being turned rearwards around the outer pulleys.
I chose to fit three fairleads to both lower wings after the wing decals were applied.
Fairleads made from 0.4 mm diameter Nickel-Silver tube.

The fuel from the gravity tank on the upper wing was transferred through a pipe, attached between the underside of the upper wing and across to the forward, left cabane strut and into the nacelle.
Made from 0.7 mm diameter Nickel-Silver tube and 0.4 mm diameter flexible tube.

Mike

4 attached images. Click to enlarge.

The size of this wire and tubes is very small, Mike (@sandbagger). It can't be that easy to find. Looks great, though.

This tubing looks great, Mike @sandbagger

Hi all,
I've pre-rigged the upper wing, nacelle and landing gear.
Now the upper wing has been fitted.
Next is to finally rig the wings before assembly continues,

Mike

1 attached image. Click to enlarge.

Oh my, that looks like a real puzzle, Mike @sandbagger
Looks like a real challenge.