Italeri model kits
457 articles
This Italeri kit was completed some time back (ca. 2014. The kit was modified to represent a
Philippine Air Force F-8"H" by reworking the nose section (narrowed and sides straightened)and radome- reduced ("H" had a [...]
1/72 Italeri, I modified the nose turret and added a Falcon vac part, hinged the guns, modified the engines and cowls and added sprue exhausts, added plastic tube and brass wire to the engines, propellers, added rudder pedals, finished in [...]
This is a OOB build with hand made decals.I hope you like it
Setting:
I reported earlier on the build and post-detailing of this Tamiya-Italeri kit out of the seventies. This build also suffered delays because of my workbench being unavailable for months due to refurbishment works in my home. The [...]
1/72 Italeri, almost OOB, finished in MM enamels with Future and MM 20000 acrylic over kit decals.
1/72 Italeri, almost OOB, I added some wire to the undercarriage and tail rotor for strength, finished in MM enamels with Future and MM 30000 acrylic over kit decals.
1/72 Italeri, I modified the rotor head, replacing some parts to separate the two rotors, finished in MM enamels with I think Tamiya X22 and MM 30000 over kit decals.
Still on the workbench and propped up to avoid strain on that original, fragile plastic nosewheel leg! - A metal leg would have been nice on this one, especially with all the weight in the nose to contend with!
1/72 Italeri, I modified and added a few things, brass tube to main rotor, cabin ceiling, wire mesh to air vents, tail rotor drive shafts and gearboxes, finished in MM enamels with Future and MM 30000 acrylic over kit decals.
1/72 Italeri, I modified, replaced and added a few things, cut the tail at the fold point, added bulkheads and drive shaft couplings, added a cabin ceiling, brass tube and wire to main and tail rotors, reversed tail rotor blades, folded [...]